Hi Guys been a while since i've been on here. Great feedback and Videos (thanks Ade) on coin changeovers. luckily i have about 70 spare mechs at home so the carrier changeover had begun. I found this a great help to me cutting a big gap in a big chuck of wood so the coin mech handle sits in nicely. So much easier to work on the mechs then.
Gud luck
Brian
Top tip coin mech changing tool
-
choice vending
- Coin Op Group Veteren
- Posts: 240
- Joined: January 20th, 2009, 5:39 pm
- Area Covered: walsall, north bham, A5 area
- Machines Used: towers, bulk vendors, kiddies rides, football tabl
- Location: Walsall, Bham, tamworth, cannock,and surrounding areas in the West Midlands
Top tip coin mech changing tool
You do not have the required permissions to view the files attached to this post.
-
dorsetvending
- Coin Op Group Grand Master
- Posts: 800
- Joined: February 7th, 2009, 5:39 pm
- Area Covered: Dorset/Somerset/Wiltshire
- Machines Used: Bulk/Towers/Pringles
- Referred by?: Yes brother - Glenn Borthwick
- Location: Dorset, Somerset, Devon
Re: Top tip coin mech changing tool
Decent tip that Brian.
Been using a flat table vice for the job. It's pretty straightforward and quite a satisfying job. Occasionally need to shave a pawl here and there...
Been using a flat table vice for the job. It's pretty straightforward and quite a satisfying job. Occasionally need to shave a pawl here and there...
-
PGBrew
- Coin Op Group Master
- Posts: 741
- Joined: August 10th, 2009, 8:47 am
- Area Covered: London & Home Countie
- Machines Used: Bulk, Tower, Pringles & various toys
- Referred by?: Sarah Hickman
- Location: London & Home Counties North of Thames
Re: Top tip coin mech changing tool
Nice tip Brian, good to hear from you.
I do 20 mechs at a time. I find it quicker to repeat same job 20 times then move onto the next.
Pete
I do 20 mechs at a time. I find it quicker to repeat same job 20 times then move onto the next.
Pete
-
Coin Operated Group
- Site Admin
- Posts: 3423
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact:
Re: Top tip coin mech changing tool
some precision cutting there Brian, what template were you using ????? looks like the saw was a bit wonky