Can anyone tell me if i'll be ok using the top black plastic part that secures the lid, and metal washer from an tub tower on a clenport Pringles tower?
I believe the pringles ones are slightly bigger, but would it work?
Tower parts on Pringles machine?
-
Venderbase
- Coin Op Group Elite
- Posts: 1276
- Joined: January 20th, 2009, 12:19 am
- Area Covered: 1
- Machines Used: 1
- Referred by?: 1
- Location: Liverpool, Wirral, Chester
-
PGBrew
- Coin Op Group Master
- Posts: 741
- Joined: August 10th, 2009, 8:47 am
- Area Covered: London & Home Countie
- Machines Used: Bulk, Tower, Pringles & various toys
- Referred by?: Sarah Hickman
- Location: London & Home Counties North of Thames
Re: Tower parts on Pringles machine?
Hi Daz,
Those black plastic securing pieces are a different spec for clenport & Chinese mcs. so if you change one, change the lock as well then it should work. I have done this for snack towers and it works ok.
Pete
Those black plastic securing pieces are a different spec for clenport & Chinese mcs. so if you change one, change the lock as well then it should work. I have done this for snack towers and it works ok.
Pete
-
Venderbase
- Coin Op Group Elite
- Posts: 1276
- Joined: January 20th, 2009, 12:19 am
- Area Covered: 1
- Machines Used: 1
- Referred by?: 1
- Location: Liverpool, Wirral, Chester
Re: Tower parts on Pringles machine?
Cheers Pete,
I've got a few lying around so i'll give them a try.
I've got a few lying around so i'll give them a try.