Change prices on my Snakky Max vendor

[tonychef]

Hi,

I've inherited a Snakky Max vending Machine and I'm trying to access the filler menu in order to change the prices. The manual is telling me that they'll be a button on the cpu that i press to access the menu and the cpu diagram disagrees and so I'm left scratching my head! Can anyone point me in the right direction?

[Coin Operated Group]

Yes there is a small button on the motherboard, its on the left hand side middle just to the right of a plug I believe.

[Coin Operated Group]

Sometimes easier to remove the metal cover so you can see but there should be a circular cutout size of a 5p coin to stick your finger in

[tonychef]

Hi Matt,

Thanks for your reply, sorry didn't get back to you sooner, been away

Had a look at the motherboard as you suggested, the only button i could see was a little round micro switch type thing on a square silver plate, but pressing it had no effect. Couldn't see any metal cover to remove (my sous chef seems to think the whole board should have been covered at one point) so i guess i'm still stuck! I'll pop back on later with a photo of the mother board i'm faced with, as soon as it arrives in my email inbox...

[Coin Operated Group]

It is that switch.

Have you got a key in power safety shut off at bottom of the machine that operates when panel with key on is open, it's a little t key should have come with machine. If not then you won't have power to machine and hence mode button won't work.

[tonychef]

That would be the yellow plastic key i'm guessing! Been wondering what that was for... lol

[tonychef]

Thanks for all your help, Matt.

T-key went in and filler menu beeped into life and three of us all stood there scratching our heads as to how we hadn't figure that out!

Thanks again mate

[Coin Operated Group]

No Probs

[isladeiona]

If you ever decide to sell it please let me know as this is the type of machines I operate.

[Alannon]

Hi I found this post and have the same issue and wanted to clarify the key you are referring to looks like a yellow piece of plastic? Where does this go exactly? When the unit is unlikely and pulled out the power disconnects presumably because the metal contact at the bottom of the pull out section disconnects the power. Does the yellow key go into that slot as I can’t see anywhere else it would be inserted into?

Thanks