Help??!??

Post by **Snackmore** » November 20th, 2015, 10:17 am

Picture of segment from the front you can see it is off centre. Best viewed in new tab

Post by **Snackmore** » November 20th, 2015, 10:25 am

I think you get the idea, the plastic segment is too far over, the dimple ring is in the right position, I have tried moving the segment round on the three cut out bits but makes no difference its out of line?

Post by **Snackmore** » November 20th, 2015, 10:26 am

View from top

Post by **Central2vend** » November 20th, 2015, 11:05 am

That the position a Chinese tower sits in.
You haven't got any bits mixed up?

Post by **Snackmore** » November 20th, 2015, 5:58 pm

What?

Dont understand, the chinese/Clenport rings fit either???

Post by **Style** » November 20th, 2015, 6:38 pm

That looks physically impossible Steve. Unless the dimple has been swapped with one from a strange manufacturer?
Andy

Post by **Central2vend** » November 20th, 2015, 7:28 pm

The Chinese towers sit about 5mm to the left and clenports
Sit central. Are you sure no parts have been swapped?

Post by **Snackmore** » November 20th, 2015, 10:11 pm

Oh dont know will double check?

Post by **Siting Services** » December 1st, 2015, 10:38 am

Did you ever get this sorted Steve?

Regards,

Barbara

December 1st, 2015, 2:13 pm

He rings me regularly asking how to change light bulbs, so I highly doubt it.

Coin Operated Group

Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??

Re: Help??!??