Polyvend - Motor Issues

[Snackmore]

My Polyvend 453 seems to have a problem in that two of the spirals are wrong so that product just drops out, I know on an old Harrington machine you could realign the motors and presume this is what I have to do here but have no idea how?

Help??

[Coin Operated Group]

Remove tray. at the back where motor sits on the back of motor that is showing, you will see two plastic clips poking out of a hole. Squeeze these together with pliers and pull the spring at the same time, it will pop out allowing you to realign.

[Snackmore]

Oh balls was hoping it would be easier than that. Getting the shelves out is a right ba5tard

Thanks Matt

[Coin Operated Group]

Pull the shelves toward you fully, then push back in a little while lifting upwards then just lift out. If you can reach to the back to remove connector plug before it makes it a little easier.

If you know where you are looking for clip to release spirals you can just about do it with tray in.

[Snackmore]

Cheers again Matt

No doubt I will be ringing you again with 32 springs left over when I have done it