Does anyone know what the lowest temperature this machine can reach is?
I'm currently set to chilled snacks and the lowest I can get is 14 degrees. Is there any way of setting it lower than this?
Any help would be hugely appreciated!
Polyvend 453
- Coin Operated Group
- Site Admin
- Posts: 3422
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact:
Re: Polyvend 453
No that's as low as possible I'm quite sure. However Have you checked on product configuration , can you change machine type ?
Main problem is the compressors are only designed to chill down to a certain level. You could always try and disconnect from machine temp control and wire in your own stat, but I do think your compressor size will limit you with that.
Main problem is the compressors are only designed to chill down to a certain level. You could always try and disconnect from machine temp control and wire in your own stat, but I do think your compressor size will limit you with that.
-
- Coin Op Group Apprentice
- Posts: 48
- Joined: October 3rd, 2014, 6:58 pm
- Machines Used: Darenth 1066 Auto VIP
- Referred by?: Google
Re: Polyvend 453
Thank you for your reply Matt, you're a fountain of knowledge as ever.
The machine setting options I have are snack, chilled snack, can, chilled can, food and outdoors.
When I set it to food the temperate is set to 4 degrees but the fan cuts out and switches the fridge off.
The machine setting options I have are snack, chilled snack, can, chilled can, food and outdoors.
When I set it to food the temperate is set to 4 degrees but the fan cuts out and switches the fridge off.
- Coin Operated Group
- Site Admin
- Posts: 3422
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact:
Re: Polyvend 453
There is a delay to switch back on , up to 3 minutes so wait and see what happens with door shut
Also when you go to temperature you can try to adjust it using the + & - keys next to the up & down key. If that doesn't work try pushing edit when on temp setting. Then using the + & - keys.
Also when you go to temperature you can try to adjust it using the + & - keys next to the up & down key. If that doesn't work try pushing edit when on temp setting. Then using the + & - keys.
-
- Coin Op Group Apprentice
- Posts: 25
- Joined: November 1st, 2012, 1:35 pm
- Area Covered: northe east
- Machines Used: hot drinks snack can bottle food table top bevmax
- Referred by?: internet
Re: Polyvend 453
Hi,
I have a lot of operated polyvend/national vendors snack machines...I install an independant thermostat to all my machines and set the temp for about 8 degrees...works fine everytime for nme
Regards
Gary
Welcome Vending
Middlesbrough
North East
I have a lot of operated polyvend/national vendors snack machines...I install an independant thermostat to all my machines and set the temp for about 8 degrees...works fine everytime for nme
Regards
Gary
Welcome Vending
Middlesbrough
North East
- Coin Operated Group
- Site Admin
- Posts: 3422
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact: