Polyvend 453

Posts about Snack/Drink vending machines
Post Reply
Ryanlt
Coin Op Group Apprentice
Coin Op Group Apprentice
Posts: 48
Joined: October 3rd, 2014, 6:58 pm
Machines Used: Darenth 1066 Auto VIP
Referred by?: Google

Polyvend 453

Post by Ryanlt »

Does anyone know what the lowest temperature this machine can reach is?
I'm currently set to chilled snacks and the lowest I can get is 14 degrees. Is there any way of setting it lower than this?

Any help would be hugely appreciated!
User avatar
Coin Operated Group
Site Admin
Site Admin
Posts: 3422
Joined: January 13th, 2009, 10:41 am
Area Covered: Birmingham, West Midlands
Machines Used: Arcade Machines, Quiz & Big Vendors
Referred by?: myself
Location: Birmingham
Contact:

Re: Polyvend 453

Post by Coin Operated Group »

No that's as low as possible I'm quite sure. However Have you checked on product configuration , can you change machine type ?

Main problem is the compressors are only designed to chill down to a certain level. You could always try and disconnect from machine temp control and wire in your own stat, but I do think your compressor size will limit you with that.
Regards Matt

www.easyvend.com
Ryanlt
Coin Op Group Apprentice
Coin Op Group Apprentice
Posts: 48
Joined: October 3rd, 2014, 6:58 pm
Machines Used: Darenth 1066 Auto VIP
Referred by?: Google

Re: Polyvend 453

Post by Ryanlt »

Thank you for your reply Matt, you're a fountain of knowledge as ever.

The machine setting options I have are snack, chilled snack, can, chilled can, food and outdoors.

When I set it to food the temperate is set to 4 degrees but the fan cuts out and switches the fridge off.
User avatar
Coin Operated Group
Site Admin
Site Admin
Posts: 3422
Joined: January 13th, 2009, 10:41 am
Area Covered: Birmingham, West Midlands
Machines Used: Arcade Machines, Quiz & Big Vendors
Referred by?: myself
Location: Birmingham
Contact:

Re: Polyvend 453

Post by Coin Operated Group »

There is a delay to switch back on , up to 3 minutes so wait and see what happens with door shut

Also when you go to temperature you can try to adjust it using the + & - keys next to the up & down key. If that doesn't work try pushing edit when on temp setting. Then using the + & - keys.
Regards Matt

www.easyvend.com
Welcome Vending
Coin Op Group Apprentice
Coin Op Group Apprentice
Posts: 25
Joined: November 1st, 2012, 1:35 pm
Area Covered: northe east
Machines Used: hot drinks snack can bottle food table top bevmax
Referred by?: internet

Re: Polyvend 453

Post by Welcome Vending »

Hi,

I have a lot of operated polyvend/national vendors snack machines...I install an independant thermostat to all my machines and set the temp for about 8 degrees...works fine everytime for nme

Regards

Gary
Welcome Vending
Middlesbrough
North East
User avatar
Coin Operated Group
Site Admin
Site Admin
Posts: 3422
Joined: January 13th, 2009, 10:41 am
Area Covered: Birmingham, West Midlands
Machines Used: Arcade Machines, Quiz & Big Vendors
Referred by?: myself
Location: Birmingham
Contact:

Re: Polyvend 453

Post by Coin Operated Group »

Which stat do you use for that gary?
Regards Matt

www.easyvend.com
Post Reply